Features
Ability to Control and Monitor Video Over IP Networks
Simultaneous IP and Analog Video and Control
H.264, MPEG-4, and MJPEG Compression
Supported Protocols: TCP/IP, UDP/IP (Unicast, Multicast IGMP), UPnP, DNS, DHCP, RTP, and NTP
Multilevel Password Protection
3 Autofocus, High Resolution Integrated Camera/Optics Packages
Horizontal Zone and Window Blanking
Sensitivity Down to 0.00015 lux PAL (35X Models)
On-Screen Compass and Tilt Display Up to 2 Simultaneous Video Streams
Web Viewing, up to 16 Cameras Simultaneously
Dual Wall Construction
Built-in Memory Stores Camera/Dome Settings
Requires 5.25-Inch Space Above Ceiling and 3.25 Inches Below
Heavy-Duty Polycarbonate Dome Bubble
Optional Protective Cage
Specs
Manufacturer Pelco
Condition New
Signal Format NTSC (DD427), PAL (DD427-X)
Scanning System Interlace/Progressive selectable
Image Sensor 1/4-inch EXview HAD
Lens f/1.4 (focal length, 3.4 ~ 91.8 mm)
Zoom 27X optical, 12X digital
Zoom Speed (optical range) 3.2/4.6/6.6 seconds
Horizontal 55.8° at 3.4 mm wide zoom
Angle of view 2.3° at 91.8 mm telephoto zoom
Focus Automatic with manual override
Iris Control Automatic iris control with manual override
Gain Control Automatic/OFF
Video Output 1 Vp-p, 75 ohms
Video Signal-to-Noise >50 dB
Wide Dynamic Range 128X
Video Motion Detection Integrated
Processor Intel Pentium 4 microprocessor, 1.6 GHz
Operating System Microsoft Windows XP, Windows Vista, or Mac OS X 10.4 (or later)
Memory 512 MB RAM
Network Interface Card 100 megabits (or greater)
Monitor Minimum of 1024 x 768 resolution, 16- or 32-bit pixel color resolution
Web Browser Internet Explorer 7.0 (or later) or Mozilla Firefox 3.0 (or later)
Media Player QuickTime 7.6.5 for Windows XP, Windows Vista, or QuickTime 7.6.4 for Mac OS X 10.4
Streaming: Bidirectional full or half duplex
Input/Output Terminal block, analog for microphone and speaker; 600-ohm differential; 1 Vp-p maximum signal level
Compression G.711 PCM 8 bit, 8 kHz mono at 64 kbit/s
Ports RJ-45 connector for 100Base-TX Auto MDI/MDI-X Autonegotiate/Manual setting
Cabling Type Cat5 or better for 100Base-TX
Input Voltage 18 to 32 VAC; 24 VAC nominal 22 to 27 VDC; 24 VDC nominal
: